Herunterladen Inhalt Inhalt Diese Seite drucken

Lightmaxx VEGA Ambient Strobe Bedienungsanleitung Seite 24

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
Static, Auto or Sound mode:
The device contains automatic programs that run according to fixed schemes
The device contains automatic programs that run according to fixed schemes (Auto) or are
recalled via the built-in microphone to match the music (Sound). The selection of the respective
. The selection of the respective
mode takes place via the menu directly on the device.
If you connect several devices of the same type via DMX, they can be controlled simultaneously
If you connect several devices of the same type via DMX, they can be controlled simultaneously
via the master device. To do this, set the desired function "Master" on the first device of the line,
" on the first device of the line,
the other devices of the series must now be set as "Slave". Now the first device of the line gives
". Now the first device of the line gives
the function to all other devices and all devices run simultaneously.
Operating mode DMX:
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
software or the DMX output of a device already in your DMX line. Always use a DMX cable with a
. Always use a DMX cable with a
110 Ohm resistor for this connection. Address the device according to your DMX configuration.
Address the device according to your DMX configuration.
The following table shows the respective DMX modes of the individual devices with the
The following table shows the respective DMX modes of the individual devices with the
corresponding values and functions:
For ideal operation in a DMX chain, it is recommended to use a terminating r
For ideal operation in a DMX chain, it is recommended to use a terminating resistor at the end of
each DMX chain. The terminating resistor is usually soldered with 120Ω between
each DMX chain. The terminating resistor is usually soldered with 120Ω between – Data and +
Data to prevent signal reflections.
Configuration of the DMX connector:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Lig0016871-000

Inhaltsverzeichnis