Indel B SW PLEIN AIRCON 12V Bedienungs, Wartungs Und Montageanleitungen Seite 46

During the assembly phases, making holes in parts of the vehicle, make sure that you do not damage
the wiring or piping of systems already installed.
AN ANTI-CORROSION PRODUCT MUST BE APPLIED TO ALL SHEET METAL SURFACES WHERE
HOLES, CUTS AND OPENINGS ARE MADE.
CAREFULLY SEAL EACH HOLE IN THE VEHICLE WALLS WITH A SUITABLE FLEXIBLE, NON-
HARDENING PRODUCT.
Use e.g.: "SikaLastomer-710", "Selleys Butyil Mastic", "Vaber SP5" or similar products.
BEFORE INSTALLING THE CONDITIONER OR CARRYING OUT MAINTENANCE,
DISCONNECT ALL THE CONNECTIONS TO THE VEHICLE BATTERY AND TO EVERY OTHER
POWER SOURCE. FAILURE TO OBSERVE THIS INSTRUCTION WILL EXPOSE THE FITTER
TO A RISK OF ELECTROCUTION AND PHYSICAL DAMAGE DUE TO THE MOVEMENT OF
MECHANICAL PARTS (PULLEYS, BELTS, ELECTRIC FANS).
If the electrical wires have to pass through walls with sharp edges, use protective pipes or
specific channels.
Securely fasten the electrical wires, paying special attention to their route along metal walls
that conduct electricity; also avoid contact with sharp elements.
When working near to the batteries (evaporator and/or condenser) pay attention not to cut
yourself on the edges of the fins.
During operations that implicate the handling of cooling fluid, remember that:
- when it is close to a source of heat it produces an unpleasant smelling gas which irritates the
eyes and the respiratory system
- a circuit containing cooling fluid must never be heated with a flame, because it is easily
inflammable
- in its liquid state, cooling fluid evaporates when it comes into contact with the atmosphere and
freezes everything it comes into contact with.
If it freezes:
- plunge the frozen part immediately into COLD water. If there is no water available, gently wrap
the frozen part in a clean cloth.
If the cooling fluid has come into contact with the eyes, rinse them thoroughly with clean water and
see a doctor.
44 SW PLEIN AIRCON 12V