Fluval SIENA 166 Gebrauchsanleitung Seite 7

Never attempt to move or transport the cabinet with the glass tank or any other load on top of it.
Although the glass tank was manufactured with the maximum care and the most advanced techniques,
we still recommend making a simple inspection prior to the installation to verify that unexpected events
during handling and transportation have not damaged the tank or impaired its water-tightness.
1. Make a visual inspection of the glass tank to check for damage or cracks.
Do not continue the installation if the tank is damaged.
2. If no damages and cracks are detected, proceed with the normal aquarium set up.
3. After the full installation of the aquarium kit with lter, heater, LED strip lights, decorations, etc.,
has been completed, ll the tank with water 2" (5 cm) at a time, while making sure there are no leaks.
Never attempt to move or transport the tank if it is not completely empty
of water or any other material.
Always take care not to damage the seals at the edges of the glass panels
while maintaining your aquarium, ie: with planters or algae scrapers.
Never use toxic or aggressive substances to clean your aquarium,
such as household detergents.
EASY CONNECTION SYSTEM INSTALLATION
This section only applies to Fluval Aquariums with Fluval External lter and "EasyConnect" System.
INSTALLING WATER INTAKE/OUTPUT WITH "EASYCONNECT" SYSTEM
(Intake/output ttings are included in the lter packaging)
These Fluval Aquarium models feature the "EasyConnect" system, which allows the direct connection
of the tank to the external lter through the bottom glass by means of special ttings. Normally,
the same type of connection is achieved through specially made devices, which are complex and
require the intervention of expert technicians.
On the contrary, in just a few minutes the "EasyConnect" system can be easily and safely installed, giving your aquarium a
professional and tidy ltration solution.
Before proceeding, identify and count all parts required by referring to the exploded
view in the side illustration. If any part is missing, do not proceed with the installation
and contact your local supplier.
Before proceeding, check stems (A) for the presence of all 3 rubber rings (C). Do not proceed
with the installation if one of the rubber rings (C) is missing and contact your local supplier.
Connector Stem's
Rubber Rings (C)
Locate the 2 openings in the tank bottom glass and assure that the corresponding opening in the cabinet is aligned with them. The 2 openings in the tank bottom glass are
complete with factory-installed special plastic ttings, which must never be removed, turned, or loosened and with 2 sealing plugs (P) and (Q). The output group should be
installed in the opening (O), whereas the intake group should be installed in the opening (I).
Do not force, loosen or turn the factory-installed special
ttings on tank openings (I) and (O).
Once the output/intake groups are installed,
do not shift the tank with respect to the cabinet
as this may damage the output/intake devices
and the glass tank.
P
Plugs
Q
TANK BOTTOM SEALING PLUGS
I
Output
Nozzles (N)
Output
Stem (B)
Intake
Strainer (S)
Connector
Stems (A)
Ring Nuts
(R)
INTAKE
GROUP
O
OUTPUT
GROUP
7