Fluval SIENA 166 Gebrauchsanleitung Seite 5

4. To avoid injury, do not come into contact with moving parts or hot parts such as heaters, LED devices, etc.
5. CAUTION – Always unplug or disconnect all appliances in the aquarium from electricity supply before placing hands in water,
before putting on or taking o parts and when these LED Strip Lights are being installed, maintained, or handled. Never yank cord
to pull plug from outlet. Grasp the plug and pull to disconnect.
Always unplug an appliance from an outlet when not in use.
WARNING: BE SURE YOU UNPLUG THE LED DRIVER FROM THE POWER OUTLET; JUST SWITCHING OFF THE APPLIANCE
WITH THE APP IS NOT ENOUGH BECAUSE IT DOES NOT STOP THE POWER SUPPLY.
Do not use the appliance for any purpose other than its intended use (i.e. don't use in swimming pools, garden ponds, bathtubs,
etc.). The use of attachments not recommended or sold by the appliance manufacturer may result in a dangerous situation. Do not
try to repair any product component: in case of damage, replace the damaged component with genuine spare parts.
6. IMPORTANT: These LED Strip Lights are AQUARIUM LUMINAIRES suitable FOR INDOOR USE ONLY designed to be assembled onto
Fluval Siena Aquariums only. For fresh and saltwater ornamental aquariums with max 35°C water temperature. Do not install or
store the appliance anywhere where temperatures may drop below freezing.
7. IMPORTANT: Make sure that the LED Strip Lights are securely and correctly installed
before operating. The LED Strip Lights must never operate in water.
Fill the aquarium up to the level indicated on the label situated on the inside of the
aquarium (see the image on the right). IMPORTANT: Do not over ll.
Over lling the aquarium can cause water to pass under the top frame which then runs down the outside of the
aquarium.
WARNING: Do not plug in the LED Strip Lights if there is water on parts not intended to be wet.
WARNING: Do not place any object(s) on the LED Strip Lights (C) or on the sliding top covers. Ensure su cient air ow
around the LED Strip Lights. The safety of the appliance is only ensured provided that it has been properly installed.
8. Read and observe all the important notices on the appliance.
9. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than
the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
SAVE THESE INSTRUCTIONS.
10.
FOR USA ONLY
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Change or modi cations not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit di erent from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without
restriction.
MAX
5