Axion STIM-X700 Bedienungsanleitung Seite 34

STIM-PRO X700
Steps to select a program (P)
Select P mode with
In program mode you can choose between 24 different
EN
programs for various areas of application. These are fully
pre-programmed - just set the intensity for the connected
channels and start the application!
The program starts immediately after selecting it.
The TENS programs run in continuous mode, recognizable
by a "C" shown on the right side of the display. The EMS
programs have a pre-defined duration of 30 minutes. The
device ends the application automatically when the time
expires. The programs can also be stopped before the end
of the program duration and do not have to be run through
completely.
To set a program, press the „MODE"
button until you reach P mode,
recognizable by a P shown in the
bottom-left corner of the display.
Press or to select the
desired program (P01 – P24). You find an overview over all
available programs on pages 34 to 37.
When you chose the program, please set the intensity for
the connected channels.
Increase intensity Decrease intensity
In P mode, the parameters are set by default and can not
be changed!
33