Before The First Use; Filling With Water; How To Use - Ufesa Black Mist Bedienungsanleitung

BEFORE THE FIRST USE

In the first use they can break off odors or fumes that sent quickly. Do not spray for the first
time on clothes and there may be traces of dirt on the steam head.

FILLING WITH WATER

Remove the mains plug from the wall socket before filling or emptying the garment. Open the
silicon cap (F) and fill the water tank (E) up to the max. Make sure that the silicone cap is co-
rrectly closed. Refill the water tank as and when required. One max. fill offers approx. 8-10
minutes of continuous use.
Your appliance was designed to operate using untreated tap water. Do not use pure deminera-
lized or pure distilled water, water from clothes dryers, scented or softened water, rain water,
filtered, bottled or boiled water, water from refrigerators, batteries or air conditioners as these
may damage the appliance. These types of water contain organic waste, mineral elements
that become concentrated when heated and cause spitting, brown staining, leaking or prema-
ture wear on your appliance. If your water is very hard, mix 50% untreated tap water with 50%
distilled water. Make sure the silicon cap is correctly closed before using.

HOW TO USE

Before using, please check fabric´s label for recommendations.
We recommended that you test acrylic, nylon or other synthetic fabrics in a hidden area to
ensure these fabrics are not damaged by hot steam.
If required, secure the brush attachment (A) by clicking it into place on the steam head (B).
Make sure that the brush attachment is the right way up, and that the steam holes are not
blocked.
Warning: always allow the garment steamer to cool down before adding or removing the
brush attachment from the steam head.
1. Hang the garment to be steamed on a clothes hanger.
2. Place the garment steamer onto a flat, stable surface, and switch it on at the mains power
supply. The garment steamer will start to heat up once it is plugged in.
3. After approximately 25 seconds of preheating, the garment steamer has reached the requi-
red temperature.
4. To begin steaming, face the steamer against the fabric keeping a certain distance, and press
the steam trigger (D). You can keep the steam trigger continuously pressed by sliding the loc-
king lever (C). Carefully steam the garment using long, straight, downwards movements to
remove any wrinkles or creases.
5. Once the garment has been steamed, release the steam trigger (D) and then switch off and
unplug the garment steamer from the mains power supply.
Warnings:
• Never point the steam jet at garments being worn, or at people or animals.
• Do not hold the garment steamer by any other part of the unit except the handle.
• During operation, the garment steamer will get very hot. Please take maximum care.
15