eta Freshie III Bedienungsanleitung Seite 24

EN
A) Standard operation (using standard bags/films)
Connect the appliance to the mains. Follow the instructions provided in Fig. 2.
1. Press the A2 button and open the cover A1.
2. If you are making a bag from a bag roll (both ends are unsealed), prepare and cut it to the
desired length first. Then place one end of the cut part on the welding seal A5 and weld
with the button B6. Fill the bag with the required raw material, insert the end of the bag
into the extraction area.
3. Close the cover A1 and press down the cover edges so as to lock it (you will hear a click).
4. Press the button with the required operation (B2, B3, B4, B5 or B6). Activated and
finished function is indicated by light B1.
5. You can now open the cover A1 (press the A2 button first) and remove the film/bag.
– Proper functionality of the appliance is assured only when using the foil/box supplied
by the manufacturer. Request these foils/boxes at your retailer. Do not use plastic
bags. At the same time you can re-weld many foods in their original packaging (eg
bags of potato chips).
– The vacuum sealer is used to seal cling foil up to the max. width of 300 mm (vacuuming max.
290 mm).
B) Using an external container and reusable bags ETA176290025 (features B2, B5)
Connect the appliance to the mains. Place ingredients to the vacuum-packing box/bag and
close tightly. Connect one end of the extraction hose to the port for external extraction A7
and put the other wide and rounded end on the box valve/air removal port of the bag.
Select the button/feature B5 or external vacuum-packing B2 as required. To open the box,
release the vacuum first by pressing down the release valve.
IV. CARING FOR YOUR VACUUM SEALER
Do not clean appliace if is hot. After each use, wipe the outer parts with a damp soft cloth.
To clean the inner parts of the appliance, wipe all pieces of food and liquids with
a paper cloth. Leave to dry properly before next use. Do not use abrasive and agressive
cleaning agents! If the power cord becomes stained, wipe it with a damp cloth. The colour
change of the surface in time is normal. This change does not change the qualities of the
surface in any way and is not a reason to return this appliance! If particles of plastic adhere
to the sealing wire, wipe them off carefully to avoid damage to the wire. If can help to carry
out a sealing operation the lid and pressing fully down without a bag in position. This will heat
the wire and soften any plastic adhering to it.
BAGS
Before reusing a bag, we recommend properly washing it in warm water with a small amount
of dishwasher detergent, and rinsing in clear water. Place the bag so that water can flow out
from inside the bag. Before reusing, dry the bag thoroughly.
VACUUM-PACKING BOX
Rinse the vacuum-packing box and parts thereof with water and detergent (or wash them
in a dish-washer). Allow all the parts to dry out properly before next use or storage.
Notice
24 / 47