Turning On/Off; Browning Level; Baking Waffles - Silvercrest SDW 1200 C1 Bedienungs- Und Sicherheitshinweise

˜ Before first use
Remove the packaging . Check if all parts are
¾
complete .
During production, some parts are covered with
¾
a thin oil film for their protection . Before first use,
operate the product without any batter on the
maximum browning level for 5 minutes . Doing do,
will make all potential residues evaporate .
Clean the product (see the "Cleaning and care"
¾
section) .
NOTE: The first few times the product is heated
up, a faint odour may be present . This is harmless
and disappears after a short time . Discard the first
set of waffles .
˜ Operation
Preparation: Grease the upper and lower
¾
plates 4 with suitable cooking oil .
˜ Turning on/off
Turning the product on: Connect the power plug
¾
6 to a suitable socket outlet . The red indicator
2 lights up .
Turning the product off: Disconnect the power
¾
plug from the socket outlet . The red indicator 2
goes off .
Light indicators 2
Red indicator on
Red indicator off
Green indicator off
Green indicator on
NOTE: During operation, the green indicator 2
goes on and off from time to time . This indicates
that the product is reheating up to the baking
temperature .
22 GB/IE
Status
Product on .
Product off .
Product is preheating/
reheating .
The baking temperature
has been reached .
˜ Browning level
Depending on your taste, you can adjust the degree of
browning of the waffles .
Turn the browning level control 3 to the desired
¾
level .
MIN:
– Low browning
MAX:
– Strong browning
NOTE: If you are unsure, begin at a medium
browning level . Adjust the browning level for the
next waffles .
˜ Baking waffles
NOTES:
Grease the upper and lower plates 4 with
¾
suitable cooking oil .
Close the product while preheating .
¾
Do not overfill the lower plates 4 with batter .
¾
While the waffles are baking, the green indicator
¾
2 will turn off and on again . This is to regulate
the required operating temperature .
The baking process takes approx . 4 minutes .
¾
Turn the browning level control 3 to the desired
¾
level .
Preheat until the green indicator 2 lights up .
¾
Open the product .
¾
Use a wooden or heat-resistant plastic ladle to
¾
pour batter onto the lower plates 4 . Do not use
metal ladles, as this could damage the non-stick
surface of the plates .