Operation - Silvercrest SDW 1200 C1 Bedienungs- Und Sicherheitshinweise

m WARNING! Risk of electric
shock! Never use a damaged
product . Disconnect the product
from the power supply and
contact your retailer if it is
damaged .
The product is not to be used if
¾
it has been dropped, if there are
visible signs of damage .
The product is powered at all
¾
times while it is connected to the
power supply .
Before connecting the product
¾
to the power supply, check that
the voltage and current rating
corresponds with the power
supply details shown on the
product's rating label .
Regularly check the power plug
¾
and the power cord for damages .
If the power cord is damaged,
it must be replaced by the
manufacturer, its service agent or
similarly qualified persons in order
to avoid a hazard .
20 GB/IE
Protect the power cord against
¾
damages . Do not let it hang over
sharp edges, do not squeeze or
bend it . Keep the power cord
away from hot surfaces and open
flames .

Operation

The product must not be left
¾
unattended while it is connected
to the supply mains .
Do not move the product while it
¾
is in operation .
Do not place the product on hot
¾
plates (gas, electric, coal cooking
range etc .) . Operate the product
on a level, stable, clean, heat-
resistant and dry surface .
Do not cover the product while it
¾
is in use or shortly after use, when
it is still hot .
Make sure that the power cord
¾
is not pinched by the plates or
touches the rim of the plates .