Rollei HS Freeze 1S Anleitung Seite 37

Warnings and Safety Instructions
– Remove the protective cap before use .
– Do not insert any objects into the product .
– Do not leave the product unattended during operation .
– The product is not a toy . Keep the product, accessories and packaging materials
away from children and pets to prevent accidents and suffocation .
– Do not discharge the flash at a very close distance to objects, people or animals .
Keep a minimum distance of approximately two metres . The flash releases inten-
se heat and may cause serious injury or damage .
– For photographic lighting purposes only . Not suitable for permanent room lighting .
– Do not film car, bus, bicycle, motorbike or train drivers while driving this product .
The driver may be dazzled and cause an accident . This also applies to unlisted
persons or groups if possible glare could cause an accident .
– Do not shine directly into the eyes of people or animals as this may cause dama-
ge to the retina, visual disturbances and even blindness .
– Ensure adequate ventilation during operation . Never cover the ventilation slits of
the unit .
– Do not use or store the unit in high temperatures or in closed rooms exposed to
direct sunlight, and do not charge the battery while doing so . The product should
not be used in ambient temperatures above 40°C .
– Note that the flash tube, modelling light and a connected reflector can become very
hot during operation . Do not touch these parts during or immediately after operation .
Allow the unit components to cool down before replacing the flash tube or reflector .
– Handle glass parts such as the flash tube with care so that the glass is not
broken . Do not touch the flash tube with bare hands, use clean cotton gloves or a
microfibre cloth . Small residues of skin grease can cause the flash tube to burst .
– Make sure that the flash tilt lever is firmly tightened before using the unit and
connecting accessories to it .
– Mount the flash unit on a tripod with sufficient load-bearing capacity and set up
the tripod so that it cannot tip over or slip .
– For storage or transport, disconnect the battery from the flash unit .
– Allow the flash to cool down before packing it for transport or storage .
37