Hilti Nuron SD 5000-22 Original Bedienungsanleitung Seite 28

▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
5.7 Changing the accessory tool
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Push the chuck towards the product, turning the chuck slightly at the same time, and hold it in this
position.
3. Remove the accessory tool with your other hand.
4. Insert the desired accessory tool into the chuck, pushing it into the product as far as it will go.
5. Refit the depth gauge to the power tool.
5.8 Forward / reverse
In the middle position, the forward / reverse selector switch serves as a switch-on interlock.
▶ Set the forward/reverse switch to forward or reverse rotation, as applicable.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Driving screws 5
WARNING
Electrical hazards There is a risk of electric shock if a screw is driven into a concealed electric cable and,
at the same time, the bit holder or depth gauge is touched.
▶ Hold the product only by the grip when driving or removing screws.
1. Set the product to forward rotation.
2. Position the screw on the bit and bring the tip of the screw into contact with the working surface.
3. Use the control switch to regulate the speed of the screwdriver.
Turn the depth gauge counter-clockwise to increase the depth to which the screw is driven.
Turn the depth gauge clockwise to reduce the depth to which the screw is driven.
6.2 Removing screws
1. Pull the depth gauge off.
2. Set the product to reverse rotation.
3. Insert the bit into the head of the screw and use the control switch to regulate the speed of the product.
4. Refit the depth gauge after removing the screws.
6.3 Switching on in sustained operating mode
1. Press the control switch and hold it in this position.
2. In addition, press the lockbutton for sustained operation.
6.4 Switching off after sustained operation
▶ Press the control switch.
▶ The lock button returns to its original position.
6.5 Product / depth gauge interface
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
22 English
3
4
7
6
2293284
*2293284*