Hilti Nuron SD 5000-22 Original Bedienungsanleitung Seite 24

▶ Keep batteries away from rain, moisture and liquids. Penetrating moisture can cause short circuits,
electric shock, burns, fire and explosions.
▶ Use only chargers and power tools approved for the specific battery type. Read and follow the relevant
operating instructions.
▶ Do not use or store the battery in explosive environments.
▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 23
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a hand-held cordless electric tool for use in drywall installation work.
The product is designed for driving and removing screws in drywall installation work. Drywall screws with a
length of up to 55 mm and a diameter of up to 4.2 mm can be used.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
Drywall screwdriver, belt hook, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
18 English
1
Chuck
@
Product / accessory interface (snap connec-
;
tion)
Universal hook
=
Motor cooling air intake
%
Grip
&
Air discharge
(
Forward/reverse switch with switch-on inter-
)
lock
Lock button for continuous operation
+
Control switch (with electronic speed control)
§
Belt hook / installation opening for acces-
/
sories
Battery
:
Battery status indicator
∙
Release button for battery
$
Work-area light (LED)
£
Depth gauge
|
2293284
*2293284*