Swim & Fun 1058 Bedienungsanleitung Seite 107

refrigerants:
- The size of the load is in accordance with the size of the room in which the
rooms containing the refrigerant are installed;
- Ventilation and air vents work properly and are not obstructed;
- If an indirect refrigeration circuit is used, the secondary circuit must also be
checked.
- The marking on the equipment remains visible and legible. Illegible marks and
signs must be corrected;
- Refrigeration pipes or components are installed in a position where they
are unlikely to be exposed to a substance that could corrode components
containing refrigerant
8. Verification of electrical appliances
Repair and maintenance of electrical components must include initial safety
checks and component inspection procedures. If there is a defect that could
compromise safety, no power supply should be connected to the circuit until the
problem is resolved.
Initial security checks must include:
• That the capacitors are discharged: this must be done in a safe way to avoid
the possibility of sparks;
• No electrical components or wiring are exposed during loading, recovery or
purging of the refrigerant gas system;
• There is continuity of grounding.
These installation instructions are an integral part of the product.
They must be given to the installer and retained by the user.
If the manual is lost, please consult the website: swim-fun.com
The instructions and recommendations contained in this manual should
be read carefully and understood since they provide valuable information
concerning the heat pump's safe handling and operation. Keep this manual in
an accessible place for easy future reference.
Installation must be carried out by a qualified professional person in
accordance with current regulations and the manufacturer's instructions. An
installation error may cause physical injury to persons or animals as well as
mechanical damage for which the manufacturer can under no circumstances
be held responsible.
After unpacking the heat pump, please check the contents in order to report
any damage.
Prior to connecting the heat pump, ensure that the information provided in
this manual is compatible with the actual installation conditions and does not
exceed the maximum limits authorized for this particular product.
MV-1058-1059-10-2021 . swim-fun.com © All rights reserved Swim & Fun A/S
UK
107