Cleaning And Maintenance - Steinberg Systems SBS-MD-20 Bedienungsanleitung

ILLUMINATION:
To turn on the backlight, hold down the VOLUME/BACKLIGHT button for approximately
2 seconds.
Another long press on the button turns off the backlight.
The backlight will automatically turn off after 10 minutes.
Caution: Since the backlight consumes more power, it is recommended to turn it off in
bright areas.
PP (PINPOINT):
When you find a metal object, you can use the PP (PINPOINT) function to determine
the precise position of the target.
1. Press the PP button The PP icon will start blinking on the display. When the PP
icon stops flashing, you can start moving the probe slowly over the selected
location. If the detector finds the target, it will beep. The display will also show
the digital readout value and the depth of the target location.
2. Press the PP button. When the "PP" icon stops flashing on the display, move
the probe, keeping the same distance. The detector will stop beeping. Move
the probe closer to the previously selected location and the detector will again
beep.
3. Repeat the above steps until the detector emits a steady signal at the target
location.
3.4.

Cleaning and maintenance

a) Turn off the unit before each cleaning.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.
d) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e) Do not spray the unit with a stream of water or immerse it in water.
f) Make sure that no water enters through the ventilation openings in the casing.
g) Clean the ventilation openings with a brush and compressed air.
h) Perform regular inspections of the unit checking technical fitness and any
damages.
i) Use a soft cloth for cleaning.
j) Do not leave the batteries in the unit when it will not be used for a long time.
k) Do not clean the unit with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the unit.
INSTRUCTIONS FOR THE SAFE DISPOSAL OF BATTERIES.