Connecting Headphones; Working With The Unit; Switching On The Detector - Steinberg Systems SBS-MD-20 Bedienungsanleitung

2. Slide the battery cover in the direction indicated by the arrow.
3. Insert two 9V alkaline batteries into the battery compartment according to the
polarity markings inside the unit.
4. Close the battery compartment by sliding the cover back.
5. Now the unit is ready for operation.
6. Replace the batteries when the battery level icon is not filled with color.
CAUTION!
CAUTION!
the batteries! Batteries can be damaged and lead to destruction of electronic
components.
CAUTION!

CONNECTING HEADPHONES

1. Choosing headphones with volume control is recommended.
2. Insert the 3.5 mm plug into the headphone socket located at the bottom right
of the control panel. When the headphones are connected, the internal
speaker is disconnected.
3. Adjust the volume.
4. Set the headphones to a low volume, then adjust the volume to the
appropriate level.
3.3.

Working with the unit

SWITCHING ON THE DETECTOR

1. Press the POWER button to turn on the unit.
Do not mix different types of batteries, or old and used batteries.
If the detector is not going to be used for a week or more, remove
Use only new batteries of the required size and voltage!