Wiring Connection; Wiring Diagram - Toshiba RAV-HM561FT-E Installationsanleitung

 Wiring connection
REQUIREMENT
• Connect the wires matching the terminal numbers.
Incorrect connection causes a trouble.
• Pass the wires through the bushing of wiring holes of
the indoor unit.
• The low-voltage circuit is provided for the remote
controller. (Do not connect the high-voltage circuit)
<How to remove the electrical control box cover>
• HM56, HM80 models
Take off screws (1) and (2) at this side of the
electrical control box and remove the drip-proof
cover.
Take off screws (3) and (4) at front side of the
electrical control box and remove the electrical
control box cover.
• HM90 to HM160 models
Take off screws (3) and (4) at front side of the
electrical control box and remove the cover of the
electrical control box.
(The drip-proof cover is provided to HM56 to HM80
models only.)
<Wiring>
• Draw the wire into the wiring hole (knockout hole).
• Attach a supplied rubber bush to the wiring hole
(knockout hole).
• Be sure to fix the connecting wires using two cord
clamps as shown in the figure. Do not apply tension
on the connecting part of the terminal block.
• Be sure to mount cover of the electrical control box
and the drip-proof cover.
Drip-proof cover
(HM56 to HM80
(1)
only)
(2)
Electrical control
box cover
(3)
(4)
Electrical control box
131-EN
<Positioning of hole for wiring (Knock-out hole) >
HM90 to HM160
HM56, HM80
Wiring hole (Knock-out hole) Wiring hole (Knock-out hole)
Refrigerant leak Power supply Remote controller
terminal block
detection sensor terminal block
①②③ A B
Earth screw Indoor and outdoor
Cord clamp*
connecting wires
* Match the cord clamp with size of connecting wires by position of
holes on the clamp to hold the wire and fix the cord clamp by
screw.
* Be sure to fix the connecting wires using two cord clamps as
shown in the figure.
10 1 2 3
10
70
50
Indoor / Outdoor connecting wire
Earth wire
See the figure on the above
for connecting wires to the
terminal block.
Indoor / Outdoor
connecting wire
 Remote controller wiring
Strip off approx. 9 mm the wire to be connected.

Wiring diagram

Terminal block for
remote controller
wiring of indoor unit
A
B
– 66 –
Terminal block
Remote
A
controller
B
unit
Remote controller wire
(Locally procured)
132-EN