Clean Air Optima CA-502Pro Mini Gebrauchsanweisung Seite 17

How to use (Filter installation for the front and the back)
1. Disassemble the panel
Put your fingers in the recesses
on the left and right side of
the device (see red icons on
the picture) and pull the panel
towards you.
2. Install the composite filter
Remove the sealing from
the filters. Place the filters back
into the device. The tab must be
visible at the front.
3. Install the panel
Push the front panel parallel along
the upper and lower edges in the
direction shown in red, see figure.
When you are hearing a click,
then the panel is installed.
Do not use the device with the filter removed.
The device needs to be positioned at least 30 cm from walls and furniture to obtain a good
air flow. Make sure that the air in-and outlets are not blocked.
17