Oven Burner - Fagor C-G920 Installations-, Gebrauchs- Und Wartungsanleitung

4.5 Conversion to other types of gas
If the appliance is prepared for a different type of gas to the one available in the installation, you should
proceed as follows:
1. Disconnect the gas supply to the appliance if connected (Any change to the conditions of the
gas circuit must be carried out by an AUTHORISED TECHNICIAN).
2. After adapting the appliance to another type of gas or to another pressure, other than that for
which it had been previously set, the old instructions should be replaced with the instructions for
the new settings, to enable unambiguous identification of the state of the appliance after
modification.
4.5.1 Top burners
1. Burner conversión:
a. Undo the control holder panel.
b. Remove the burner injectors and replace with the correct model according to the gas to
c. Set the air control to position H (table 3) depending on the gas to be used.
2. Pilot conversión:
a. Remove the grille, the diffuser and the body of the burner.
b. Release the pilot unit and lift upwards.
c. Remove the pilot injectors and replace with the correct model according to the gas to be
d. Refasten the pilot unit and replace the elements previously removed.
4.5.2

Oven burner

1. Burner conversión:
a. Remove the base of the oven.
b. Remove the burner injectors and replace with the correct model according to the gas to
• The general installation must have a mains tap and a pressure regulator and it is
also advisable to install a shut-off cock on each individual appliance.
• A pipe of at least Ø 12 x 10 mm should be used for the gas connection, together
with a ¾" nut to connect to the cooker.
be used (table 3).
used (table 3).
be used (table 3).
46