Assembly Of Equipment In Blocks; Gas Connection - Fagor C-G920 Installations-, Gebrauchs- Und Wartungsanleitung

Place the appliance in a sufficiently ventilated room, in accordance with the current regulations, to
prevent the formation of unacceptable concentrations of harmful substances in the installation site.
If the wall is not able to withstand temperatures of 150 ºC, the appliance should be installed at a
distance of at least 100 mm. Appliances must only be installed on and/or against fireproof surfaces.
Inspect final location of the machine prior to installation to prevent damage during use.
Unless otherwise indicated, the parts that have been protected by the manufacturer must not
be manipulated by the installer.
4.3

Assembly of equipment in blocks

To assemble the equipment in blocks, proceed as follows:
• Remove the controls.
Dismount the control holder panels.
•
Remove the chimney trim.
•
Place adhesive tape around the edges of the worktop to be joined.
•
Apply sealant suitable for use in zones in contact with food on the sides to be joined.
•
Join the machines together.
•
Attach the machines using nuts and bolts both at the rear (tabs) and at the front (holes in the side
•
panels accessed once the control holder panels have been removed) (see image). In case of
assembly with a tilting pan use the hole marked in blue.
• Tie the machines with a bolt and a nut in the lower front part (see image).
Remove any excess sealant.
•
Remove the adhesive tape.
•
Replace the control holder panels and the controls.
•
4.4

Gas connection

An AUTHORISED TECHNICIAN should always carry out the gas connection of the appliance.
45