Maintenance And Care; Minimize Wear And Avoid Damage; Maintenance Work; Wear Parts - Stihl KG 550 Gebrauchsanleitung

9 Maintenance and Care

9 Maintenance and Care
The following intervals apply for normal operating
conditions. The specified intervals must be short‐
ened accordingly when working for longer than nor‐
mal or under difficult cutting conditions (extensive
dust, etc.).
Complete unit
2)
Air filter
Circular brush and
2)
sweeper roller
Gearhead
Safety information label
1)
STIHL recommends STIHL dealers
2)
KG 770 only
3)
see "Inspection and Maintenance by User".
10 Minimize Wear and Avoid
Damage
Compliance with the specifications of this
Instruction Manual will avoid excessive wear and
damage to the machine.
The machine must be used, maintained and
stored as carefully as described in this Instruc‐
tion Manual.
The user is responsible for all damage caused by
failure to comply with the safety, operating and
maintenance instructions. This applies in particu‐
lar for:
– Product modifications not authorized by STIHL
– The use of attached parts that are not author‐
ized by STIHL
– Use of the machine in a manner not in keeping
with the intended use
– Consequential damages due to continued use
of a machine with defective components
0458-767-9921-F
visual inspection (condi‐
tion)
Clean
Clean
replace
visual inspection (condi‐
tion)
Clean
Have replaced by serv‐
1)
icing dealer
3)
lubricate
replace
X
X
X X
10.1

Maintenance work

All of the tasks listed under "Maintenance and
Care" must be carried out periodically. If the user
does not carry out these maintenance tasks him-
or herself, they should be delegated to an
authorized STIHL dealer.
If these tasks are not performed, this may result
in damage for which the user is responsible.
Among other things, this includes:
– Damage to machine due to delayed or insuffi‐
cient performance of maintenance
– Corrosion damage and other consequential
damages due to improper storage
– Damage and consequential damage due to
use of non-original STIHL spare parts.
– Damage caused by maintenance or repair
work in unauthorized STIHL workshops
10.2

Wear parts

Some parts of the machine are subject to normal
wear and tear even when the machine is used in
conformity with its intended use. These parts
must be replaced in due time, depending on the
English
X
X
X
X
X
X
25