Bleed The Rear Hose; Bleed The Remote - Rock Shox XLoc Full Sprint Bedienungsanleitung

B l e e d t h e R e a r H o s e
1. While holding both syringes upright, push on the rear shock syringe plunger and pull up on
the remote syringe plunger at the same time. This will force fluid and any air bubbles through
the hose and into the remote syringe. Continue to push on the rear shock syringe plunger
until the syringe is nearly empty.
2. Push on the remote syringe plunger until the syringe is nearly empty and pull up on the rear
shock syringe at the same time. You should see air bubbles and hydraulic fluid moving into
the rear shock syringe.
3. Cycle the hydraulic fluid between the remote assembly syringe and the rear shock syringe,
until no more air bubbles transfer into either syringe.
Pressing the remote actuator multiple times during the bleed process can dislodge bubbles
that may be trapped in the remote.
4. Push on the rear shock syringe plunger a final time until the rear shock syringe is nearly
empty.
5. Unthread the syringe from the rear shock bleed port. Use a T10 TORX® wrench to thread the
rear shock bleed screw into the bleed port. Use a torque wrench with a T10 TORX bit socket
to tighten the bleed screw to 1.7 N∙m (15 in-lb).
B l e e d t h e R e m o t e
1. Gently pull up on the remote syringe plunger to remove any remaining air bubbles from
inside the remote, then push on the plunger to force fluid into the remote. Repeat this
process until no more air bubbles transfer into the syringe.
2. Push on the remote syringe plunger a final time, then remove the syringe from the remote
bleed port. Use a T10 TORX® wrench to thread the remote bleed screw into the bleed port.
Use a torque wrench with a T10 TORX bit socket to tighten the bleed screw to 0.5 N∙m
(4.4 in-lb).
14

Bleed the ReaR hose