Switching The Laser Beam On/Off; Infrared Temperature; Selecting The Unit; Selecting The Measurement Mode - Wohler IR Temp 310 Bedienungsanleitung

9 Switching the laser
beam on/off
10 Infrared tempera-
ture
Fig. 15: Surface temperature
11

Selecting the unit

12 Selecting the mea-
surement mode
12.1 THB – Thermal bridge detection
To switch the laser beam off and on again
•
during the measurement, keep the measure-
ment key pressed and simultaneously press
the down key.
Keep the measurement key pressed.
•
The surface temperature in the selected unit (°C
or °F) appears in the middle of the display.
Press the °C/°F key to switch between the
•
units.
You can switch between the units at any time.
Exception: It is not possible in the mode for setting
the emission value (E) and the alarm limits (HAL
and LAL)
• Press the mode-key to switch between the
modes.
When the device is switched off and on again, the
last mode called up is activated.
Plug the external temperature sensor for
•
measuring the ambient temperature into the
connection socket.
Switch on the device and keep the measuring
•
key pressed.
The surface temperature is displayed with the
following warning functions.

Switching the laser beam on/off

EN
35