4 Markings on the product
Do not remove the safety markings or cover them with
adhesive labels or paint.
Depending on the ladder design, not all of the safety
markings described below will appear on the ladder.
General markings
Read the instructions in their entirety. Additional
information on the ladder is available online.
Falling from the ladder may cause
serious injuries.
Never use a damaged ladder. Inspect the ladder
for signs of damage upon delivery and before
every use.
The maximum load capacity may not
be exceeded.
The maximum load capacity may not
be exceeded.
Do not use the ladder on an uneven or
unstable surface.
Avoid leaning out of the product's sides.
Only one person may be on the ladder
at any time.
Always face the ladder when climbing or
descending it.
Never use the ladder to bridge a gap.
The ladder should only be used with
a horizontal stabiliser installed.
The ladder is suitable for both
commercial and household use.
Do not set up the ladder on a soiled surface.
OI L
H
O
2
Ensure you grab on to the ladder securely
when climbing or descending it.
Avoid work that involves exerting a lateral load
on the ladder, e.g. drilling into solid materials
to the side of the ladder.
While using the ladder, do not carry heavy or
KG
bulky equipment.
Wear appropriate shoes while climbing
the ladder.
Do not use the ladder if you have limited physical
ability. Be aware of your health and physical
condition. Consumption of medications, alcohol
or drugs is detrimental to safety.
Identify all risks posed by electrical equipment in
the working area, e.g. high-voltage power lines
or other exposed electrical equipment. Do not
use the ladder if there are electrical risks.
Product-specific markings
The ladder must be set up in a correct position,
e.g. the proper ladder angle (65° to 75°).
The treads of the single ladder have to be in a
horizontal position.
When using a single ladder to access greater
heights, ensure that the ladder extends at least
1 m beyond the resting point and secure the
ladder where necessary.
The ladder may only be used in the
orientation specified.
en
9