Operating Instructions; Making Bags From Magic Vac Rolls; Vacuum Packing With Bags Cut From A Roll Or Pre-Cut Bags; Vacuum Packing In Magic Vac - effenne Inova Bedienungsanleitung

Before use, always thoroughly clean your appliance and
any accessories coming in contact with food (contain-
ers, caps, jars etc.) as directed in the "INSTRUCTIONS
FOR CLEANING" paragraph.
1 Positioning the appliance
Position the appliance in a dry place on a level surface,
making sure that the work area in front of the appliance
itself is clear of obstacles and there is enough room to
accommodate the bags with the food to be packed. Plug
the power cord into a power socket corresponding to the
voltage of the appliance (see technical details).
2 Tips on using bags
MAGIC VAC bags are available in two widths: 20 and 30
®
cm. Choose the bag size suited for the food you intend to
preserve. Check that the bag you are going to use is at
least 8 cm longer than the food to be packaged, taking
into account an additional 2 cm for each time the bag will
be subsequently reused.
Note: If you are using pre-cut bags, go directly to step 4
below.
3 Making bags from MAGIC VAC
- Unroll a bag of suitable length and cut it using the
MAGIC Cutter (12) as shown in Fig. A, moving it from
rim to rim. Now you can seal an open side of the cut
bag as follows:
- Lift the lid (2) and turn it in the open position.
- Seal either of the two open ends of the bag by posi-
tioning it on the sealing gasket (8) with the smooth side
facing down (fig. B).
Warning: be careful not to let the bag hang over into the
vacuum chamber (9) or on the sealing gasket (7).
- Close the lid (2) and push down on the front corners of
the lid with your thumbs, then push the LOCK buttons
(5) into the locked position (fig. C). The appliance will
automatically carry out the complete vacuum packing
cycle. Wait until the ON/SEAL light goes off (1).
- Press down on the rounded recessed area of the man-
ual valve (3) to release the lid (fig. D).
- Lift the appliance lid putting the fingers under the cen-
tral projecting part and remove the bag.
- Check the quality of the seal obtained, which should
appear as a regular, wrinkle-free crosswise strip with
no internal ridges in the bag (fig. E).
4 Vacuum packing with bags cut from a roll or pre-cut
bags
- Lift the lid (2) and turn it in the open position.
- Place food in the bag without creasing it excessively
or stretching surfaces. Eliminate any liquids or food
residues from the area inside the bag that will be
sealed.

OPERATING INSTRUCTIONS

Warning: Do not store the machine with the LOCK buttons engaged
rolls
®
- Place the bag and its contents in front of the appliance
and place the open end inside the vacuum chamber (9)
with the smooth side facing down (fig. F).
- Close the lid (2) and push down on the front corners of
the lid with your thumbs, then push the LOCK buttons
(5) into the locked position (fig. G). The appliance will
automatically carry out the complete vacuum packing
cycle. Wait until the ON/SEAL light goes off (1).
- Press down on the rounded recessed area of the man-
ual valve (3) to release the lid (fig. H).
- Lift the appliance lid putting the fingers under the cen-
tral projecting part and remove the bag.
- Check the quality of the seal obtained, which should
appear as a regular, wrinkle-free crosswise strip with
no internal ridges in the bag. (fig. I)
- You can interrupt a packaging cycle already in
progress at any time by means of the manual valve (3),
keeping it pressed until the machine turns off.

5 Vacuum packing in MAGIC VAC

ers or in containers sealed with MAGIC VAC
Universal Caps with new knob
MAGIC VAC ® Executive containers and the MAGIC VAC
Universal Caps with star-shaped knob (see fig. L) make
vacuum packing easier, because the connection hose
can be directly introduced into the knob central hole (see
fig. M).
MAGIC VAC
® Universal Caps, available in two diameters
(100 mm and 125 mm), are to be used on jars for preserv-
ing food and bowls and receptacles made of tempered
glass. The Universal Caps work just like the Caps for
MAGIC VAC ® Executive containers.
WARNING: When using Universal Caps do not use plas-
tic or glass containers that are not suitable since they
could implode under the vacuum pressure of the appli-
ance and cause injury.
- Fill the container leaving at least 3 cm of room between
the contents and upper rim. Place the lid on the con-
tainer and turn the knob to the "VACUUM" position (fig.
L).
- Connect the container lid knob to the appliance air
inlet (4) by means of the connection hose (13) (fig. M).
- Lock the lid (2) by pushing the LOCK buttons (5); the
machine will carry out a vacuum packing cycle and
turn off automatically on its completion.
- Remove the hose from the container lid knob.
- Turn the knob to the "CLOSED" position.
- To open the containers turn the knob to the "OPEN"
position, you should hear a hissing of air as it enters
the container. This sound guarantees that the contents
have been packed in a vacuum.
16
® Executive contain-
®
®