Ec Declaration Of Conformity - Makita UH4260 Betriebsanleitung

After operation, remove dust from both sides of the blade
with wired brush, wipe off it with a rag and then apply
enough low-viscosity oil, such as machine oil etc. and
spray-type lubricating oil.
CAUTION:
• Do not wash the blades in water. Failure to do so may
cause rust or damage on the tool.
Storage
Put the blade cover on the shear blades so that the blades
are not exposed. Store the tool out of the reach of children
carefully.
Store the tool in the place not exposed to water and rain.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Extension cord
• Blade cover
• Hook complete
• Waist cord hook
• Arm cord hook
EC-DECLARATION OF CONFORMITY
The undersigned, Kato, as authorized by, declare that the
MAKITA machines,
TYPE:
UH4260, UH4860, UH5260
complies with the standard safety and health
requirements of the pertinent EU guidelines:
EU machinery guideline 98/37/EC, Noise emission
2000/14/EC, EU EMC guideline 2004/108/EC.
The requirements of the above EU guidelines were
implemented chiefly on the basis of the following
standards: EN60745-2-15, EN 55014, EN61000. The
conformity assessment procedure 2000/14/EG was
performed per Annex V. The measured sound pressure
level (L ): is 87.6 dB (A). The measured sound power
pA
level (L ) is 93 dB (A). The guaranteed sound power
wa
level is 96 dB (A).
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745-2-15:
Vibration emission (a
Uncertainty (K): 1.5 m/s
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
ENH020-1
2
): 6.7 m/s
h, D
2
CE 2008
Tomoyasu Kato
Director
9