Storage Of Wine Bottles; Bottle Loading Method; Bottle And Shelf Safety - MQuvee WineExpert Bedienungsanleitung

4.3 The item will be used under the room temperature
ranging from 16 to 38 °C (61-100 °F).
4.4 Temperature setting range of cabinet is 5~20°C (41~68
F°) . Customers can set the temperature according to their
actual demands.
Remark:
• There is no heating element for single zone, so temperature for
single zone will be affected by the ambient temperature.
• Both the wine cooler and the indicator will turn on until the desired
temperature is achieved. Single Temperature zone is the same
operation.
• The temperature readout shows the actual cellar
temperature, it will temporarily show the set temperature while
making adjustments, then reverts back after 5 seconds without any
operation.
• Temperatures may fluctuate depending on whether the interior light
is ON or OFF and depending on the position of the bottles.
• The temp. of the top compartment must be set lower than
the bottom compartment, or at the same temp. as the bottom
compartment, but it cannot be set at temp. higher than the bottom
compartment.
12

4 . STORAGE OF WINE BOTTLES

4.1 BOTTLE LOADING METHOD

• Wooden shelf capacity: 4,5,9 or 11 bottles/shelf.
• Bottom shelf capacity: 5, 8 or 12 bottles /shelf.
• Maintain a minimum 20mm between bottle and back plate.
• Ensure storage Bottle bottom Dia.78mm & Height 300mm,
otherwise, less Bottle loading.

4.2 BOTTLE AND SHELF SAFETY

Ensure bottle and shelf safety, check the following tips:
1. Spread your bottles out as evenly as possible over the shelves, so
weight is not concentrated in one point, and make sure your bottles
will not touch the back of the cabinet
2. Make sure bottles are not all grouped together at the top or bottom
of the cabinet
3. Following loading instructions provided in section 2, according to
the type of storage fixtures with which your cabinet is equipped, and
never stack bottles on a sliding shelf.
13