Use Of Extension Cords; Wine Cooler Installation; Wine Cooler Features And Use Initial Setup - MQuvee WineExpert Bedienungsanleitung

1.3 USE OF EXTENSION CORDS

Avoid the use of an extension cord because of potential safety hazards
under certain conditions. If it is necessary to use an extension cord,
use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot outlet that will accept the plug. The marked rating of the
extension cord must be equal to or greater than the electrical rating of
the appliance.

1.4 WINE COOLER INSTALLATION

1. When you receive the cabinet, please unpack the unit and make
sure there is no flaws in its external appearance (from shocks,
deformation, ect.)
2. Open the door and check all interior fittings and supplied items if are
all complete (shelves, instruction, control panel, etc.) Please install it
according to the following points if the shelves or shelf brackets fall
off during transit.
3. After checking, if no problem, then, pls carry to the final place, which
should be care as follows:
(A) Leaving space of minimum 5cm between your wine cooler
and left and right wall; at least 8cm between back of cabinet
and the wall.
(B) Position the wine cooler on a flat level surface, if not, adjust
the feet of wine cooler to keep level.
4. Away from sources of heat and high humidity areas (laundry room
and bathroom, etc).
5. Do not tilt it at an angle of more than 45° when move the cabinet.
Allow a minimum 10 minutes interval between transit and
re-starting.
6. Make sure the ventilation is free if you wish to install your cabinet
into a worktable, otherwise, it will reduce the effect of usage.
4

1.5 WINE COOLER FEATURES AND USE INITIAL SETUP

• Before connecting the wine cellar to the power source, let it stand
upright for approximately 24 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
• Once you have plugged the unit into an electrical outlet, let the
unit run for at least 30 minutes to acclimate before making any
adjustments.
• The wine cellar can be set to any temperature between 5°C~20°C
(41°F~68°F) to accommodate your wine storage requirements.
Shelving (Type and number of shelves will vary per model)
• Remove packing materials from shelves once unit is stable and ready
for storage.
• Disperse the bottles evenly to avoid concentrating weight in one
place. Bottles must not touch either the back of the cabinet or the
step at the bottom. .
• Make sure that the bottles are not all grouped together either at the
top or bottom of the cabinet.
• Only pull out one rolling shelf at a time. Never attempt to pull more
than one.
• The wine cellar will hold 'standard' Bordeaux sized bottles, as shown
below. If up to half of your collection consists of non-standard
Bordeaux-size bottles, your maximum capacity may be reduced
by 20-25%. If your collection consists mostly of these larger sized
bottles, your maximum capacity may be reduced by as much as 40%.
5