General Information; Technical Characteristics - Felisatti NTF250/1200ST Bedienungsanleitung

INTRODUCTION
Congratulations on your purchase of a new series
FELISATTI mitre saw, a high-quality product that will
complete your set of professional tools. This new
series represents the further evolution of the
renowned mitre saws developed by FELISATTI.
If any malfunctions ever occur during operation,
you will always be able to rely on the network of
authorised Assistance Centers. All FELISATTI
movable tools comply with Standard EN 61029,
Machine Directive 98/37/EC and amendments,
with 2006/95/EC and 93/68/EEC, and in regard to
electromagnetic compatibility, with Directive 89/336/
EEC, EN 55014.1, EN 55014.2, EN61000.3.2 and EN
61000.3.3 and EN 50366.
If used with the care and serviced regularly, this tool
will provide long-lasting and reliable service. Carefully
follow the instructions contained in this manual, using
them for reference for any eventual controls that may
need to be carried out.

1 GENERAL INFORMATION

1.1 THE AIM OF THIS MANUAL
This manual has been prepared by the Manufacturer
as an integral part of the mitre saw equipment. The
information contained is for the benefit of professional
operators. This manual defines the purpose for which
the mitre saw was designed, and contains all the
information necessary to ensure safe and correct
use. We therefore recommend reading the manual
carefully before proceeding to any form of adjustment,
operation or maintenance. Constant respect for the
contents of this manual ensures both machine and
operator safety and the most economical and longest
working life of the machine itself. Photographs and
drawings have been supplied by the manufacturer for
exemplifying purposes; with the aim of following
a policy of constant development and product
modernisation, the manufacturer is entitled to make
modifications without forewarning.
1.2 MITRE SAW IDENTIFICATION
Plate A (fig. 1) provides mitre saw model information
and technical data of the motor and of its manufacturer;
Plate B provides mitre saw model identification.
1.2.1 IDENTIFICATION (fig. 1)
A Data plate
B Logotype plate
C Upper table
D Movable upper casing
E Handgrip
F Machine lock pin
G Lower support stroke-end raised section
H Turntable
I Fixed casing
J Blade
K Machine lock knob 0°- 45°
L Turntable lock knob
M Movable lower blade protector
N Upper table fine adjustment
O Release lever
P Base
Q Support
R Main body
S Upper table locking knob
1.3 MANUFACTURER – IDENTIFICATION
Interskol Power Tools S.L.
Carretera de Sant Joan de les Abadesses s/n17500
RIPOL, (Girona), SPAIN
Tel +34972700200 - Fax +34972700554E-mail:
e-mail: felisatti@interskol.es

2 TECHNICAL CHARACTERISTICS

A sturdy, high-reliability structure ensures that these
mitre saws will be able to cut wooden boards and
PVC and aluminium pipe in industrial environments
at no expense to the machine essential handiness
or portability. All models are equipped with spacious
upper tables that permit the mitre saw to be easily
transformed into a disk saw to perform cuts of up to
40 mm thickness, engraving, facing, and trimming.
Only one operator is required for the use of the mitre
saw, which has been designed and constructed in
compliance with Standard EN 61029. All models are
equipped with release switches featuring LOCK in
'ON' buttons. All models come with minimum voltage
circuits that prevent the accidental restarting of the
machine after interruptions in power supply because
in such cases the operator is always required to reset
work conditions; a high-power and high-efficiency
asynchronous motor ensures silent operation at all
rpm levels. The machine also comes with a motor
brake that permits the blade to be stopped within 10
seconds of the release of the button on the switch.