Standard Accessories; Safety Devices - Felisatti NTF250/1200ST Bedienungsanleitung

2.1 TECHNICAL DATA
Model
Tension and current
Frequency
Absorbed power
Idling speed
Cut at 90°/crop (AxB fig. 3)
Cut at 45°/crop (AxB fig. 4)
Cut at 45°/blade at 45° (AxB fig. 6)
Cut at 45°/blade at 45° (AxB fig. 6)
Cut on upper table
Upper table dimensions
Blade diameter
Blade hole diameter
Weight
Overall dimensions (LxHxW)
Sound pressure emitted
Sound power emitted
Vibration level
* Reliefes enforced by the standard: EN 61029

2.2 STANDARD ACCESSORIES

This series of mitre saws is supplied complete with
the following set of standard accessories:
Adjusting rod (fig. 7): required for the cutting of beams
of the same length.
Pusher For the working of small parts on the upper
table (fig. 20).
Blister pack of Allen wrenches.
Important: the equipment provided may vary
according to the sales campaign in progress.
2.3 ACCESSORIES AVAILABLE ON REQUEST
The following accessories for particular work
conditions are also available on request:
Rapid clamp: (fig. 8) permits the tighter locking of
bars and sections without vibration.
Foldable and movable universal support for mitre
saws (A fig. 19).
Support and roller unit (B fig. 19) for jutting piece
Vacuum unit (C fig. 19) with connection tube and
spout.
Goniometer: to make angled cuts on the upper
table
(fig. 21).
Workpiece support stroke-end raised section (G
fig.1
WARNING! The use of accessories or attachments
other than those recommended in this manual may
pose risk of injury.
NTF250/1200ST
V / A 230V-5,5A
Hz 50
W 1200
/min 4500
mm 73x150
mm 73x90
mm 46x150
mm 45x48
mm 40
mm 473x312
mm 250
mm 30
kg 22
mm 520x396x650
Lpa dB(A).(*) 91
Lwa dB(A).(*) 104
m/s2 (*) 1,0 (<2,5)

2.4 SAFETY DEVICES

In rest position, the blade is completely protected
by two fixed casings and one movable casing with
opening that is automatically triggered by the lowering
of the blade unit during the execution of the cut.
On the upper table, the blade is protected by a casing
that is raised over the workpiece as it approaches the
cutting point.
WARNING! Never remove these protective casings
that enable the operator to work in conditions of
safety.
WARNING!
CHECK ALL DAMAGED PARTS
• All the parts of the tool should be carefully checked
before use in order to make sure that they will work
correctly for the operation foreseen.
• Check the alignment and assembly of all moving
parts for signs of breakage and any other conditions
that might compromise operation.
• Damaged protective casings and/or other parts
should be replaced by an authorised service center
unless indicated otherwise in this manual.
• Have defective switches replaced by an authorised
service center.
If the LOCK in "ON" button has not been pressed,
the blade automatically stops when the starting
lever switch in the handgrip is released.
WARNING!
Pressing the LOCK in "ON" button disables the safety
feature provided by the Manufacturer in the starting
NTF305/1600ST
230V-8A
50
1600
4000
102x150
97x102
66x150
45x53
66
473x312
305
30
25
573x432x667
96
109
0,7 (<2,5)