Petsafe In-Ground Fence Bedienungsanleitung Seite 16

Set the boundary distance and test the receiver collar
8
With the boundary wire in place and properly connected, it's time to set the boundary distance and test the system.
1. First, make sure the:
• Transmitter is on and the boundary distance is set to 3.0 metres.
• Receiver collar is on and set to tone and vibration only.
2. Hold the receiver collar at your pet's neck height, angled as it will be when it is worn by your dog (with the front of the collar facing the
boundary wire and the contact points angled upward toward you).
3. Starting inside the pet area, approach a straight section of your boundary wire that is at least 15 metres long. The collar will tone and
vibrate and the stimulation level lights will flash. Walk back into the pet area until the beeping stops.
16