HOMCOM 824-004 Montageanleitung Seite 13

9.DISPLAY LED- can be switched off temporarily by pressing the DIS-
PLAY button on the remote control or by pressing and holding the MODE
button on the control panel from more than 3 seconds,the display will
light up again once any control button is activated.
FIGURE 4
824-004/824-005
MAINTENANCE
1. This can only be done by an authorized service agent such as your
local Sealer dealer or any agent qualified to undertake electrical repairs.
2. If the unit requires external cleaning make sure it is switched off and
unplugged from the mains supply. Use a soft tissue or cloth for general
cleaning. To remove more persistent dirt or grime wipe down with a cloth
that has been dampened with warm soapy water. Do not use any
solvents ( such as thinners ) as these may damage the plastic casing.
Notice
1. This appliance is not intended for use by persons (including children)
with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with
appliance.
3. If the supply cord is damaged, it must be replaced by the manufac-
ture, its service agent or similarly qualified persons in order to avoid a
hazard.
-13-