Zipro Beat Bedienungsanleitung Seite 23

EN
4. Install the handlebar post
Connect the computer sensor cable (17) from the main
frame (1) to the connecting cable (18) in the handlebar post
(4).
Next, connect the resistance adjustment cable (16)
to the other connecting cable (16) as shown in the
picture.
Slide the nut of the upper resistance adjustment
16
cable (16) into the slot in the post of the lower
18
resistance adjustment cable (16), pull and tighten
the upper cable (16) and move the lower cable
post (16) vertically. Cable nut should be on the
post as shown in the picture.
Insert the handlebar post (4) into the main frame
(1) and fix it with bolts (19) and curved washers
17 16
(27).
5. Install the handlebar
Run the heart rate measurement cable (24) through
the slot in the handlebar post (4) and pull it from the
top of the handlebar post (4).
Fix the handlebar (5) to the handlebar post (4) with
the spring washer (25) and the Allen bolt (19).
23