Inhaltsverzeichnis
Werbung
Fax +32 2 359 95 50
EMPTYING THE DUST COLLECTOR
Press the release button of the dust container (F) and pull the dust container out.
•
Hold the dust collector over a dustbin, press the unlocking button at the
bottom of the dust collector to open the lower cover of the dust container
and spill the rubbish (G).
•
Close the dust collector and put the dust collector back in the appliance until it locks in
place.
CLEANING THE FILTERS
Filters
The filter system consists of: 1 multi-cyclone filter to vacuum the smallest particles (in the dust
It is necessary to clean the filters regularly to avoid operating problems.
Air filter
This air filter (situated behind the grid at the left side of the appliance) guarantees fresh air
during cleaning. It should be replaced approximately every 3 months (depending on the
operating frequency).
1.
Switch off the vacuum cleaner and disconnect the plug from the mains. To do this
always pull on the plug and not on the cable.
2.
Open the exhaust air grill (H) (this is at the rear of the cyclone vacuum cleaner.)
3.
The exhaust air filter is visible when the grill has been opened.
4.
Rinse the filter under cold running water and allow dry.
Caution! Only ever clean the filter with clean water and do not use soap or detergent.
These would destroy the filter.
5.
Put the exhaust air filter back into place (or replace with a new one) and place in the
grill.
6.
Close the exhaust air filter grill.
NOTE: After a certain number of cleanings the filters will be damaged or impossible to get back
in their initial shape. In such case, please contact the nearest customer service to obtain new
filters.
Cleaning the dust collector
• Switch off the vacuum cleaner and disconnect the plug from the mains. To do this
always pull on the plug and not on the cable.
• You can press the lock button of the dust container together with the out of their
anchoring with the aid of the carrier handle on the dust container. Now lift out the dust
container and carry it to the waste bin.
• A push button is located on the dust container that you can use to open and empty it
automatically (bottom-down technology). To do this hold the dust container over your
dustbin and press on the empty button.
• Clean the inside of the dust collector and the lid with the multi-cyclone filter with a
damp cloth or sponge, but make sure they are totally dry before using the appliance
again.
• Close the lid. Put the dust collector back in the appliance until it locks in place.
Cleaning the HEPA filter
The HEPA filter and the HEPA cover should be cleaned regularly. Cleaning is best done when
emptying the dust container. To do this follow the instructions in the Emptying dust container
section.
1.
Switch off the vacuum cleaner and disconnect the plug from the mains. To do this
always pull on the plug and not on the cable.
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
container)
1 air filter, to vacuum the smallest particles
64
Assembly page 64/67
special
instruction
from
TKG VC 1022 - 170214
Team
Werbung
Inhaltsverzeichnis
