Lavor FIT 35B Bedienungsanleitung Seite 56

38. Remove the exhaust air fi lter support (25) from the appliance by pressing the fi xing tab (26) in
the direction of the arrow (Fig.38).
39. Clean the fi lter cartridges (27) with a jet of air (Fig.39), from a distance of at least 20 cm.
Careful maintenance of the exhaust air fi lters guarantees a longer vacuum motor life. To replace the
fi lter cartridges, proceed as follows:
• Remove the fi lter cartridge supports (28) from the fi lter support (Fig.40).
• Remove the worn fi lter cartridge (27) from the fi lter cartridge support (28) and replace it with
the new one (Fig.41).
• Repeat the operations in reverse order to reassemble alt the parts.
40. Insert the exhaust air fi lter support (25) in the appliance (Fig.42).
41. Rotate the appliance to its work position (Fig.43).
42. Block the handlebar in the vertical position; to release the
handlebar, move the stop in the direction of the arrow (Fig.44).
43. Rotate the front cover (4) as far as it will go - do this with the aid of the handle (5) (Fig.45).
44. Insert the two tanks and the detergent solution fi lter cartridge in the appliance, positioning
fi rst the detergent solution fi lter cartridge, then the solution tank, and fi nally the recovery tank.
45. Rotate the front carter (4) as far as the work position - do this with the aid of the handle (5)
(Fig.46).
46. Insert the battery in the battery-holder compartment in the rear part of the appliance (Fig.47).
47. Position the appliance with its rear part in contact with the fl oor (Fig.48).
56
EN