Lavor FIT 35B Bedienungsanleitung Seite 50

9. Remove the recovery tank cover (8) ( Fig.7).
ATTENTION: protective gloves should
always be worn before handling detergents
or acidic or alkaline solutions,to avoid serious
injury to the hands.
10. Empty the tank.
11. Rinse the inside of the tank with a jet of
water. If necessary , use a spatula to remove
the sludge that has accumulated at the
bottom.
12. Position the recovery tank cover (8) on the
tank.
13. Fix the cover on the tank.
14. Remove the solution tank from the device
(Fig.8) .
15. Remove the detergent solution fi lling cap
(9) from its seat on the solution tank (Fig.9).
16. Empty the tank.
17. Rinse the inside of the tank with a jet of
water.
18. Replace the detergent solution fi lling cap
(9) in its seat on the solution tank (Fig.10).
19. Insert the two tanks in the appliance,
positioning fi rst the solution tank and then
the recovery tank.
50
8
7
EN