Lavor FIT 35B Bedienungsanleitung Seite 53

12. Remove the recovery tank (9) from the appliance .
13. Remove the recovery tank cover (10) (Fig.10).
14. Use a jet of water and then a damp cloth to thoroughly clean the rotation fulcrum (11) of the
vacuum motor fl oats (Fig.11).
15. Use a jet of water and then a damp cloth to thoroughly clean the central fl oat (12) (Fig.12).
16. Clean the dirty water conveyor compartment with a jet of water; the entrance hole to this
compartment is identifi ed by the letter (A), while the outlet is identifi ed with the letter (B)
(Fig.13). (Fig.13).
17. Clean the vacuum motor air conveyor compartment with a jet of air; the entrance hole to this
compartment is identifi ed by the letter (C), while the outlet is identifi ed with the letter (D)
(Fig.14).
Clean the fi lter located inside the outlet (D).
Using the machine for a long time without using water may lead to suction problems.
18. Fix the cover on the recovery tank.
19. Remove the solution tank from the device (Fig.15).
20. Remove the fi lter cartridge (13) and clean it under a jet of water to remove any dirt that might
be attached. If necessary, replace it (Fig.16).
21. Remove the vacuum duct cleaning brush (14) from its support (Fig.17).
22. Clean the inside of the vacuum duct (15) with the brush (14) (Fig.18).
23. Replace the vacuum duct cleaning brush (15) on its support (Fig.19).
24. Rotate the front cover (4) as far as the work position - do this with the aid of the handle (5)
(Fig.20).
EN
53