Risk Of Electric Shock; Before And During Installation - Klugmann KO608TCX Bedienungsanleitung

Risk of electric shock!

• When replacing the lamp of the baking area, there might be electrical contact on the live
lamp holder. Before replacement, unplug the product or switch off the fuse.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Warning for cleaning!
Never use steam cleaners to clean the oven.
•
Unplug during cleaning.
•
Start the cleaning procedure only after making sure that the oven is completely cold.
•
Do not use sharp objects when cleaning the glass.
•

BEFORE AND DURING INSTALLATION

• Installation of the product must be done by the Authorised Service Agent.
• Test the product inside a kitchen cabinet to check if overheating part avaliable.
• The product must be inserted into the installation cabinet so that its rear surface faces the wall.
• Before using the product, make sure to remove all packaging materials.
• Use the product only for the purposes described in the user manual.
• The product is specifically intended for domestic cooking purposes. It is not suitable for
industrial or laboratory use.
• Do not use or leave the product outdoors, outside domestic conditions.
• Do not use the product anywhere near water, on wet floors or near pools.
• The product is not intended to be used with external times or remote controllers.
• It must not be used by children, people with mental disabilities or people with no experience,
unless they are supervised by a competent person who is responsible for them.
• If the door of the appliance or seals on the door are damaged, the product must never be used
unless it is repaired by the authorised service agent.
• Do not let the power cable hang from the edge of the table or counter. All maintenance and repair
works must be done by the authorised service agent only, and only original spare parts must be
used.
• This product is heavy. Be careful when moving it.
• Before first use, remove all packaging materials and protective films.
• Make sure that the voltage used is in compliance with the power type stated on the rating lebel.
• Do not make any modifications on the product.
• Only use the temperature probe recommended for this oven.
• The oven must not be installed behind a decorative door. This may cause overheating.
• Use voltage of your oven is 220-240 V AC 50-60 Hz.
7