Design; Advantages And Equipment - GOK FST3.1VK Montage- Und Bedienungsanleitung

DESIGN

Protective cap with chain for plug with shrouded contact
Limit indicator with sensor and probe tube
Test connection with shut-off device
Pressure gauge connection with sealing nut
for tank testing

ADVANTAGES AND EQUIPMENT

The compatible FST3.1VK type overfill prevention device as part of an assembly comprising:
gas withdrawal valve
and test connection
The compatible FST3.1VK type overfill prevention device is intended exclusively for
withdrawal from the gas phase. At the bottom of the overfill prevention device is the limit
indicator with sensor. This is connected to the plug with shrouded contact
cable. The limit indicator (sensor with probe tube) can be replaced at tank pressure. A shut-off
valve which closes under tank pressure when replacing the limit indicator and thus
prevents gas leakage is installed below the sensor to this end.
Filling can be monitored using the dip valve
Compatible FST3.1VK type overfill prevention device, available dip lengths (different
dip lengths upon request)
FST3.1VK with
Dip length 250mm
Dip length 310mm
Dip length 360mm
Dip length 365mm
Dip length 450mm
Dip length 470mm
Dip length 500mm
Part no. 55 270 52
FST3.1VK type compatible overfill prevention device
, dip valve , overfill prevention device
.
Order no.
55 220 14
55 220 00
55 220 31
55 220 32
55 220 71
55 220 05
55 220 11
In accordance with EN 14570, as a
combination fitting, the compatible GOK
overfill prevention device has the
following equipment:
Inlet connector
Outlet connector
Gas withdrawal valve with handwheel
Safety pressure gauge as a
pressure gauge which cannot be
shut off, measurement range 0 to
25bar
Dip valve with calibration tube
Plug with shrouded contact for
connection of the connector part of
the overfill prevention device of the
road tanker
Calibration tube
Shut-off valve (not visible)
Screws x2
.
, safety pressure gauge
by an internal
L
1
5 / 16