Safety; Accident Prevention And Safety; Safety Instructions - Schwamborn BEF 320EX Originalbetriebsanleitung

EN Floor milling machine BEF 320EX / BEF 320VX

2 Safety

2 Safety
This chapter contains a summary of the most impor­
tant information on safety when handling the
machine.

2.1 Accident prevention and safety

The following instructions comply with legislation, di­
rectives and publications such as:
— EC Machinery Directive
— EC Product Liability Directive
— Law on technical materials
— Law on equipment safety
— Law on product liability
This operating manual is intended for operators and
tool setters, as well as for the personnel that service,
maintain and repair the machine. Together with all
the technical documentation, it is intended to help
— avoid hazardous situations
— use as intended
— avoid downtime and repair costs
— maintain the function of the machine
— increase the service life of the machine
The manufacturer and owner of the machine must
observe the contents and provisions of the EC direc­
tives. The effectiveness of any measure ultimately
depends on how well all parties, i.e. the manufac­
turer, the owner and the machine operators, work
together to uphold safety standards.
All laws and regulations (e.g. the valid regulations on
waste disposal), accident prevention guidelines and
generally recognised safety rules must be complied
with when working on and with the machine!

2.2 Safety instructions

This machine incorporates state of the art technology
and has been built in accordance with recognised
safety regulations. This ensures that the highest pos­
sible standards of occupational safety are main­
tained. However, incorrect use of the machine could
endanger the health and lives of the personnel or
cause material damage.
The machine may only be operated by people
who have been assigned to do so and who have
the appropriate training and skills!
If any defects are found in the machine that
could endanger people or damage property,
stop the machine immediately and ensure that it
cannot be used again until all repairs have been
completed!
The operating and maintenance personnel
responsible for the machine must ensure that no
one can enter the machine's danger zone during
operation or maintenance work!
Risk of injury if safety equipment has been re­
moved or is non‐functional! The safety
equipment must be checked for completeness
and function before start‐up!
The safety equipment must be mounted during
operation.
When working on the machine (set‐up,
maintenance, service, repair, cleaning, etc.) ...
BEF 320EX:
... the power supply of the machine must be
disconnected from the mains
Disconnect mains [26, Fig. D].
BEF 320VX:
... the drive motor and the milling rotor must be
at standstill.
Turn the fuel valve [30, Fig. E]and the motor
OFF
switch [32, Fig. E] to
(! HONDA operating manual)
BEF 320EX:
High‐voltage electrical current can be fatal! Only
connect the machine to power supplies
equipped with a ground fault circuit breaker.
The power socket serving as the electric supply
should be supported and installed according to
local regulations.
All installed plugs and couplings have to be pro­
tected from splash water!
Only suitably knowledgeable, qualified
professional electricians may perform work on
any electrical parts of the system.
17