Contact Details - EWT Desk Friend DDF250B/W Bedienungsanleitung

- See Fig 1.
1. Power indicator light
2. Standby thermostat
3. Air outlet grille
4.
5. Safety tilt switch
The heat output is controlled by the
thermostat, according to the local
area temperature.
Turn the thermostat knob fully
clockwise to maximum setting
initially. When the area is warm
enough, reduce the setting slowly
Fig. 2
The heater will now cycle on and off to maintain your local
area temperature. An audible click may be heard when the
thermostat operates - this is normal.
If the heater does not come on when the thermostat
is at a low setting, this is normally because the local area
is warmer than the thermostat setting and is not a fault.
Position ' ' will put the heater into standby mode (unless
the temperature is approximately 5°C). This is a special
setting to enable the product to be used as a charger
throughout the year.
In the event that the product overheats, the cut-out switches
the heater off automatically. To bring the heater back into
operation, remove the cause of overheating, then turn off
the electrical supply to the heater for a few minutes.
switch on the heater.
If the cut-out operates repeatedly, contact your supplier.
the heater gets accidentally knocked over the product will
not operate.
supplies a 5V 2.1A supply. Please ensure that your device
WARNING ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powders or polish
of any kind on the heater.
Wipe with a dry cloth to remove dust and a damp cloth (not
wet) to clean off stains. Be careful not to allow moisture
into the heater.
heater as this could lead to overheating of the element.
accumulate.
see Fig. 2
This marking indicates that this product
should not be disposed with other household
harm to the environment or human health
from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse
of material resources. To return your used device, please
use the return and collection systems or contact the retailer
where the product was purchased. They can take this
product for environmental safe recycling.
Should you require after sales service please contact the
retailer from whom the appliance was purchased or contact
the service number relevant to your country on the warranty
card.
instance as this may result in loss or damage and delay in
providing you with a satisfactory service.
In the interests of further development, the appliance may
prior notice.
Please retain your receipt as proof of purchase.
Minimum heat output (indicative)
Maximum continuous heat output
At nominal heat output
At minimum heat output
In standby mode
Mechanical thermostat room temperature control

Contact details

DDF250B/W
Pnom 0.25
Pmin 0.25
Pmax,c 0.25
elmax 0.0
elmin 0.0
elSB 0.0
GDHVI
Dunleer, Co. Louth,
Ireland
kW
kW
kW
kW
kW
kW
Yes