Kinderkraft B-TOUR Bedienungsanleitung Seite 27

WARNING!
• Use a harness as soon as the child can sit unaided.
• The pram body is intended for children from birth to 15 kg.
• The head of the child in the pram body should never be lower than the body of the child.
• The pram body must not be used as a child carrier. The pram body handle is only designed for assembly and disassembly
on the buggy frame.
• Do not insert an extra mattress apart from that supplied with the product.
The following applies to the pushchair :
WARNING!
• This seat unit is not suitable for children under 6 months
• Always use the restraint system
The product is intended for children from 6 months old to 22 kg or 4 years whichever come first.
Applies to Kinderkraft car seat:
• Kinderkraft B-TOUR is available also in a set with a compatible Kinderkraft car seat.
• The product is intended for children from birth to 13 kg.
• If the seat is used together with the chassis, it does not replace a cot or bed. For sleep, place the child in a suitable pram
body, cot or bed.
• Use only parts and accessories supplied or recommended by the manufacturer.
I Elements of the stroller
1. Frame with a basket (2)
3. Parent handle
4. Front wheels x2
5. Rear wheels x2
6. Safety bar
7. Seat/carrycot (2 in 1)
8. Part of the frame (seat/carrycot)
9. Canopy
II INSTALLATION OF THE STROLLER'S FRAME In order to pre-unfold the frame (1) with a basket (2), unlock the hook (Fig.
A), and then simultaneously pull both free ends of the frame until you hear a lock click (Fig. B). Slide axles of rear wheels
(5) into the appropriate holes until you hear a locking sound (Fig. C). Slide front wheels (4) into holes until you hear a lock
click (Fig. D). Slide ends of the parent handle (Fig. 3) into free ends of the frame (Fig. E). Make sure that latches are secured.
WARNING! The buggy has pumped wheels. Do not exceed the
maximum permissible pressure in the wheels, the value is
indicated on the wheel tyres.
WARNING! Before using the buggy, make sure that all the
wheels are properly installed.
III INSTALLATION OF THE PRAM BODY Start the assembly of the carrycot by inserting the loose part of the frame (8) into
holes in the carrycot (7) (Fig. F). Make sure that latches are secured. Then put straps located on the loose part of the frame
through holes in the carrycot/seat cover and close the zipper around the perimeter of the attached part (Fig. G). Set the
bar under the carrycot with the use of straps and secure with snap fasteners (Fig. H). The carrycot can now be secured to
the stroller's frame (you will hear a locking sound on both sides of the stroller) (Fig. I). When using the stroller (carrycot
version), straps on the sides of the seat (2 on the left side and 2 on the right side) and under the footrest must remain
unfastened. NOTE! Shoulder straps, lap straps and the crotch strap must be removed through holes located in the seat.
The disassembly of the belts is described in chapter XI. Place the mattress (15) in the carrycot. The small mattress (15)
included in the kit should only be placed in the carrycot configuration. NOTE! When the child starts to sit independently,
attach an additional harness to the attachment points shown in the picture (Fig. J).
10. Cover for feet
11. Car seat adapters x2
12. Bag with a changing mat (13) and hangers x2 (14)
15. Mattress
16. Cup holder
17. Rain cover
18. Mosquito net
27