Cleaning And Maintenance; Emptying The Robot's Dust Bin - Venga VG RVC 3000 BK Bedienungsanleitung

CLEANING AND MAINTENANCE

To keep your Venga! robot reliable and operating at peak performance, please perform
the following care procedures. If you notice the robot picking up less dust or debris from
your floor, then please empty the dust bin and clean the filter and the rolling brush.
Cleaning the brushes is important as hair may remain stuck and block them.
Recommended cleaning/replacement frequency:
Dust bin
Filters
Rolling brush
Side brushes
Brush guard
Charging pins
Swivel wheel
A spare parts kit is available on Amazon under the name: SP VG RVC 3000 KIT
(ASIN reference: B081HHJYY8). It is suitable for VG RVC 3000 WH / VG RVC 3000 WH BS /
VG RVC 3000 BK / VG RVC 3000 BK BS.

Emptying the robot's dust bin

1. Press the bin release button to remove
the dust bin.
Cleaning the robot's filter
1. Remove filter by pulling the white tab.
VG RVC 3000_[IB]-7L_NEW.indd 13 VG RVC 3000_[IB]-7L_NEW.indd 13
Cleaning Replacing
After each use -
Once every week Every 2 months
Once every week Every 6-12 months
Once every month Every 3-6 months (or when visibly worn)
Once every month When the silicone rubber strip on the
brush guard becomes visibly worn
Once every month -
Once every month -
2. Open dust bin's hatch to empty it.
2. Brush the HEPA filter (white) with the cleaning
tool. You can also vacuum it with a crevice
tool, if possible. Clean the foam filter (black)
with water. Make sure it is dry before putting it
back in the case.
ENGLISH
EN
VG RVC 3000 - 13
16/06/22 13:24 16/06/22 13:24