Cleaning Schedule - Venga VG RVC 3000 BK Bedienungsanleitung

ENGLISH
EN

CLEANING SCHEDULE

1. Setting the clock on the remote control
Press the button on the
remote control.
The hour section begins
to flash in the clock display
setting window.
2. Setting a cleaning schedule
Press the button on the
remote control, and then the
hour section begins to flash
in the clock display setting
window.
3. Canceling a cleaning schedule
Press and hold the
robot will beep twice when the cleaning schedule has been cancelled completely.
Note:
• Make sure the remote control is located near the robot while setting the clock
or schedule as it has to communicate with the robot.
• The clock works with the 12-hour time system. Make sure you use the right time period
(AM = morning, 00:00 to 11:59. PM = afternoon, 12:00 to 23:59).
• The start of the scheduled cleaning cycle can be about 5 minutes off the set time.
12 - VG RVC 3000
VG RVC 3000_[IB]-7L_NEW.indd 12 VG RVC 3000_[IB]-7L_NEW.indd 12
Press the ▲ or ► button
to select the desired figures.
Press the ◄ or ► button
to select the minute or hour
section.
Press the ▲ or ► button to
select the desired figures.
Press the ◄ or ► button to
select the minute or hour
section.
button for approximately 4 seconds on the remote control, the
Then press the button.

The robot will beep when
the clock setting is
completed.
Then press the button.

Make sure the robot beeps
to confirm the schedule.
It will start the automatic
cleaning mode every day
at the scheduled time.
16/06/22 13:24 16/06/22 13:24