S&P TD-500/150-160 SILENT Bedienungsanleitung Seite 12

ENGLISH
EN
This instruction manual contains important infor-
mation and must be read carefully by competent
persons prior to any handling, transport, inspec-
tion or installation of this product. Every care has
been taken in the preparation of the instructions
and information; however, it is the responsibility of
the installer to ensure the system complies with
relevant national and international regulations,
especially safety. The manufacturer, Soler & Palau
Sistemas de Ventilación S.L.U. accepts no respon-
sibility for breakages, accidents or any inconven-
ience caused by failure to comply with the instruc-
tions contained in this manual.
The fans referred to in this manual have been
manufactured in accordance with rigorous quality
control and International standard ISO 9001. Once
the product has been installed, this manual to be
retained by the end user.
WARNINGS
Any work including transport, installation, in-
spection, maintenance, service spares replace-
ment, repair and fi nal end of life disposal must be
carried out by competent persons and supervised
by competent executive. Fan equipment should
be electrically isolated and locked out before any
work started. This fan must not be used in haz-
ardous area.
The Installer, User is responsible for ensuring
that the fan is installed, operated and serviced by
qualifi ed personnel, acting in accordance with all
safety precautions applicable and as required by
law, regulations and standards in the country ap-
plicable.
Safety protective clothing, equipment, hearing
protection, and tools may be required.
All fans are designed and manufactured in accord-
ance with EC Directive. Safety guard accessories
are available from S&P if required due to specifi c
installation.
This instruction manual is subject to modifi cations
due to further technical developments of the fan
described, images and drawings may be simpli-
fi ed representations. Due to improvements and
modifi cations the fan operated may differ from the
representations. We reserve the right to vary the
product without prior notice.
Working ambient temperature for fan equipment
12
should not be exceeded, typically this will be within
-20°C to +40°C, unless stated otherwise.
Allow safe access to fan for inspection, mainte-
nance, replacement of parts, cleaning / house-
keeping.
The user is responsible for effective maintenance,
replacement of parts, cleaning, especially where
dust may form inside the fan.
Do not remove safety protection guards or open
access doors when the fan is in operation.
If the fan is used in atmospheres with more than
95% Relative Humidity (RH), consult the S&P
Technical Service fi rst.
If the fan is used to extract air from premises
where a boiler or other combustion appliance is
installed, make sure that the room has suffi cient
air intakes to ensure adequate combustion.
The following risks have been identifi ed for con-
sideration:
• Installation: incorrect installation or function
represents a risk to safety.
• Rotational speed: identifi ed on fan name plate
and motor. Never exceed this speed.
• Rotation of impeller: identifi ed on fan with di-
rection arrows. Do not run impeller in reverse.
• Working temperature: identifi ed on fan name-
plate and motor. Never exceed this range.
• Foreign bodies: ensure no risk from debris, or
material that could be drawn into fan.
• Electrical risks: motor name plate data should
never be exceeded, effective connection to
earth, and all checked regularly every 6 months.
• Protection devices: These should always be
operational and never disconnected. However,
Emergency ventilation fan and motors are suit-
able for S1 duty cycle, and one off emergency
smoke operation no motor protection devices
must stop this. The fan motor power supply
must be designed to accommodate any motor
protection devices, where applicable, for S1 duty
cycle and these must be disabled or by-passed
in event of one off emergency smoke opera-
tion. Power supply cables to fan motor must be
suitable for temperature and time stated when
installed in potential fi re area. Power supply
should be via a protected source to enable fan
to run under emergency fi re smoke conditions,
Direct on line.