Dahlert DT-SJ-19 Bedienungsanleitung Seite 20

20
SEPARATING AND WASHING
※
If the unit is not cleaned immediately after use, the pulp may dry and stick to the unit. This will make
disassembling and cleaning difficult and may also lead to performance degradation. Do not wash with hot
or boiling water, an iron scrubber, abrasive material, sink solvents, or sharp cleaning tools. Do not put it in a
dishwasher or dish dryer. After washing, thoroughly and naturally dry, and store in a clean area.
4DC01742 사용설명서 DT-SJ-19(102-A2) 7개국어_V.00.indd 20
※ After the product has completely stopped
operating, unplug the power cord with your
dry hand.The motor will stop slowly even when
you stop the machine.Separate the chamber
set approximately 3 seconds after the machine
comes to a complete stop.
Remove the chamber set from the main body.
01
Twist the hopper to open and lift up in order to
disassemble the unit.
Use a cleaning brush and wash the chamber set
02
under running water.
For chamber, open the lift lever and juice cap to
03
wash.
Clean the main body with dried towel or soft
04
cloth.
In the case of packings made of silicon, remove
05
and wash them after use.
(Screw packing, Juice cap packing, Lift lever
packing, Chamber packing)
Soak in the mixture of water, baking soda, citric
06
acid, or vinegar for 30 minutes for sterilization.
2019-08-13 오후 6:28:11