Snooze Function; Timer Function; Setting And Operating The Kitchen Timer; Cancelling The Kitchen Timer - Silvercrest SKR D1 C3 Bedienungs- Und Sicherheitshinweise

NOTES:
When the alarm sounds, press
the alarm off .
When Alarm 1 sounds,
display .
[ 4 ]
The volume gradually increases .
After the alarm duration has elapsed,
the product will return to standby mode
automatically .
<FM> or <DAB> alarm: When the alarm
sounds, the radio station appears on the
display .
[ 4 ]
˜ Snooze function
In ON mode, press and hold SELECT/
ENTER/SNOOZE
ringing . The alarm reactivates after approx .
9 minutes .
˜ Timer function
The product has a practical kitchen timer with
which you can monitor cooking and baking times,
for example . You can set 2 kitchen timers .
˜ Setting and operating the
kitchen timer
Press TIMER/SLEEP
Timer 1 and Timer 2 .
Turn VOLUME/START/RESET
the countdown time .
Push VOLUME/START/RESET
confirm . T1 or T2 appears on the display
The countdown starts immediately .
Press TIMER/SLEEP
countdown time .
A warning signal sounds at 30, 15, 10 and
5 seconds before the countdown elapses .
20 GB
to turn
3 ] [
flashes on the
while the alarm is
1 ] [
to toggle between
9 ] [
to select
7 ] [
to
[ 7 ]
4 ] [
to check the
[ 9 ]
At the end of the countdown, an alarm signal
sounds at maximum volume . Press any key to
turn the alarm off . T1 or T2 disappears from
the display
[ 4 ]
NOTES:
Timer 1 can be set from 1 minute up to 3 hours
59 minutes in increments of 1 minute . If you set
the countdown between 1 and 4 minutes, the
time will be shown in "mm:ss" format . If you set
the countdown to 5 minutes or more, the time
will be shown in "hh:mm" format .
Timer 2 can be set from 5 minutes up to
3 hours 55 minutes in increments of 5 minutes .
The time will be shown in "mm:ss" format .
If you do not make any changes to the settings
for about 15 seconds, the product will switch
back to the previous operating mode without
saving the settings .
˜ Cancelling the kitchen timer
Briefly press TIMER/SLEEP
timer you wish to cancel (T1 or T2) .
Push and hold VOLUME/START/RESET
for 2 seconds until
display .
[ 4 ]
˜ Power reserve
The power reserve is used to store data /
settings if the product has been accidentally
disconnected from the power supply .
In the event of a power failure, the display will
.
extinguish, the clock will continue working, but
there will be no alarm .
.
to select the
9 ] [
Off
appears in the
7 ] [