Parallel Operation - CGM 2200I Benutzerhandbuch

4
Allow the generating set run at no load for a few
minutes to stabilize internal temperatures of the
engine and generating set.
5
Turn the two-in-one switch to "OFF" position.
5.

Parallel operation

(If applicable)
Make sure that the generating set is in a good
running state before connecting it to other
generating sets. The total power of electric devices
should not exceed rated power of generating set.
When electric motor starts, the overload indicator
(red) will light up and normally it will stop within 4
seconds. If it cannot stop, please consult your local
dealer.
During parallel operation, energy-saving switches
of generating sets should be in the same position.
1
Connect one generating set to other generating set
(s) in parallel. Use the parallel kit to make the
parallel connection (the parallel kit needs to be
purchased separately).
2
Start the engine in proper order and make sure that
the running indicator (green) is normal.
3
Connect the plug of electric devices to the AC
receptacle of parallel kit.
4
Run the electric devices.
CAUTION
When overload too much, overload indicator
(red) blinks continuously, and the generating set
may be damaged. When overload a little,
overload indicator (red) lights up continuously, it
may shorten the service life of generating set.
When continuously operating the generating set,
power cannot exceed the rated power of
generating set.
The total power of electric devices cannot exceed
the rated power of generating set. The
manufacturers of electric devices or tools always
list the rated power of similar models or serial
number.