CGM 2200I Benutzerhandbuch Seite 59

DANGER
If connected devices overheat, turn them off and
disconnect them from generating set.
DANGER
ELECTRICAL SHOCK
To reduce the risk of electrical shock, DO NOT
use electrical cords that are worn, frayed, bare or
otherwise damaged.
DO NOT touch bare wires or receptacles.
DO NOT handle generator or electrical cords
while standing in water, or barefoot, or while
hands or feet are wet.
Loading capacity
WARNING
DO NOT overload the generating set.
Exceeding the generating set's capacity can
damage the generating set and/or electric devices
connected to it.
You must make sure your generating set can supply
enough rated (running) and (starting) watts for the
electrical devices at the same time. Follow these
simple steps to calculate the running and starting
watts necessary for your purposes.
a. Count the electrical devices you will power at
the same time.
b. The amount of power you need to run with the
devices is the total rated (running) watts of
these items.
c. Starting power is the power needed shortly
when electric devices start. Since not all
devices start at the same time, starting power
can be estimated by the maximum power of all
devices plus the total power counted in step
''b".
WARNING
It is necessary to equip with circuit protector or
switch to isolate the generating set from the
electric utility when the generating set is mainly
used for backup. Failure to isolate the generating
set from the power utility may result in injury or
death to electric utility workers and damage to the
generating set due to back feed of electrical
energy.