Safety Instructions - auna MD-640 Bedienungsanleitung

EN
14

SAFETY INSTRUCTIONS

Installation instructions
• This radio is designed to operate on 12 volts. Before installation, check
that the voltage of your vehicle matches the voltage of the unit.
• Disconnect the negative terminal of the car battery before installation
to avoid electric shock, personal injury or short circuits.
• When installing, only drill in places where there are no cables or wires.
• Do not connect cables over or near hot surfaces. This is especially true
for the cables that are connected to the machine parts.
• The power cable must not be removed or used for other radio models.
Overloading could cause fires.
• Replace old fuses with new ones of the same type.
• Use the screws supplied with the unit for installation.
• Once all cables are connected, bundle the cables into one strand with
tape.
• Do not use the unit in wet, humid or dusty environments.
• Do not install the unit in a highly vibrating or unprotected location. Do
not block ventilation slots and openings on the unit.
General Instructions
• Do not modify or disassemble the unit to prevent fire and electric shock.
• For the sake of road safety, do not turn up the volume too loud.
• When washing the car, be careful that no water enters the unit.
Otherwise this could cause short circuits or other damage.
• If you are not sure about the connections and cables during installation,
we recommend that you consult a professional who has the necessary
experience.
• If you notice that the unit is no longer functioning properly in any way,
do not continue to use it. To avoid damaging the unit, have it checked
by a specialist immediately.
• The unit contains many sensitive individual parts. Do not attempt
to disassemble the unit and service or adjust the parts yourself. If
necessary, contact our customer service or a specialist company.