Important Safety Notice - Paramondo JAM 2000 Montageanleitung

Transport and storage
The packaging of the awning must be protec-
ted against wet and damp. Soaked packaging
can come loose and cause accidents.
Transport the awning to the place of instal-
lation in the correct direction for fitting to
prevent turning it in small spaces.
If the awning is to be installed in an elevated
area, the area underneath must be blocked
off when the awning is raised so that nobody
is under the suspended load.
Proceed in the same manner when uninstal-
ling the awning.
The awning must be protected against
penetrating damp when in storage!
Awnings must be stacked and unstacked so
that they do not prove a hazard to persons
due to tipping over or rolling out of position.
Only create storage facilities and stacks
that can securely take the load. Ensure that
the permissible loads of shelves and other
load-bearing components are not excee-
ded.
You must comply with the general goods
storage principles.

IMPORTANT SAFETY NOTICE:

The ceiling or floor clamps must be absolu-
tely firmly attached to the mounting sur-
face. For non-pressure-resistant mounting
surfaces, use an aluminum shim if neces-
sary.
Test run
Persons must not stand in the moving area
or beneath the awning when it is extended
for the first time. The fixing materials must
be visually inspected after the first extensi-
on.
Installation
To make sure that the awning is correctly as-
sembled and thus ensure the optimal perfor-
mance of the finished product, the following
instructions must be observed:
Perform the fitting work in accordance with
the applicable occupational health and safe-
ty guidelines and standards.
Safety ropes and/or safety belts fixed to the
articulated brackets may only be removed
after testing the attachment of all compo-
nents.
Check all equipment (scaffolding, ladders,
tools, etc.) and safety equipment (belts, ro-
pes, etc.) for da,age prior to use.
Always use suitable protective equipment
(gloves, safety boots, goggles, hearing pro-
tection, etc.).
If several persons work on the system, their
activities must be coordinated.
The working area beneath the awning must
be blocked off and protected to ensure that
persons cannot walk beneath the suspended
load without any protection.
The fitting and service personnel must be
instructed in accordance with all safety regu-
lations.
The position chosen by the user for the ins-
tallation of the product has to be such that
an adequate load-bearing capacity and the
necessary space for opening the awning in
its entirety is guaranteed.
The maximum load capacity of the non-
retractable parts is 800 pa.
Climbing aids:
Do not lean climbing aids against, or fix them
to, the awning. They must stand firmly and
provide sufficient support. Only use climbing
aids with sufficient load-bearing capacity.
www.paramondo.de
Safety instructions
21